NitorLACK pearly - 400ml aerosol

pearly - 400ml aerosol

This semi-transparent colourless nitrocellulose lacquer develops a fine and smooth pearlescent effect when applied over any coloured base coat.

Colours for vintage-inspired guitars
After great work and exhaustive study by our laboratory and technical department, we have created colours for guitars to faithfully recreate the tones of vintage Fender and Gibson guitars to paint electric guitars. They have been based on original samples from the Ôæë50s and Ôæë60s. However, keep in mind that vintage guitar colours may have changed a lot over the years due to the aging of nitrocellulose lacquer and changes in the brandsÔæí own colours. Therefore two guitars finished in 1960 with Fender card colours can look different between them or with respect to a more current guitar today.

Nitrocellulose lacquer gloss aerosol spray
At NitorLACK we have developed all our guitar colours in spray format nitrocellulose so you donÔæít need professional painting equipment to paint your guitar. You can achieve a professional finish with our entire range of products, from coloured base coats from our entire range up to nitrocellulose top coat lacquers in gloss and matte.

How much spray product do I need to buy to paint a guitar?
It will depend a lot on the type of wood and the amount of product that is applied for each coat and the desired finish, mirror effect or Ôæìopen poreÔæî. But in general, to paint a guitar with a medium wood pore:

Ôæï

Electric guitar neck: 2 cans of nitrocellulose clear finish (gloss or matte)
Ôæï

Electric guitar body: 1 can of nitrocellulose coloured base coat, 3 cans of nitrocellulose clear finish (gloss or matte)
Ôæï

Classic or acoustic: 1 can of nitrocellulose coloured base coat, 4 or 5 cans of nitrocellulose clear finish (gloss or matte)
Ôæï

Ukulele: 2 cans of nitrocellulose clear finish (gloss or matte)
Ôæï

If you want to apply any colour between the base coat and the clear finish you should add 1 or 2 cans of the desired guitar colour.

Spray application tips
Shake vigorously for 2 to 5 minutes before applying. It is recommended to apply the spray in thin layers and with an ambient humidity that is as low as possible. Apply with a uniform movement and with a distance of approximately 20 cm. It is important to apply a primer and sand with 400 grit sandpaper before applying the spray, to achieve a uniform surface before colouring or finishing. Sand between coats and allow to dry for 12 to 24 hours between coats. Apply in ventilated areas.